Expert Answers about Thor Tahoe Fifth Wheel

• Could Stromberg Landing Gear # LG-2 Fit 2001 Tahoe 28DB
• If what you have looks like a Stromberg Carlson then most likely the part # LG-2 would drop right in as this is a very standard setup that can fit in place of most sets of landing gear. The legs of this are 2-1/2 inch square like you have so the mounts would fit in that regard. The distance between your stops though is a little off so you might have to have new ones welded on. The standard dimension is 17-1/2 inches from outside to outside. The crank would end up in the same location as...
  view full answer...


• Can Trailer Landing Gear Box be Removed from Trailer with Jacks on Ground
• If you were to remove the landing gear box from the set like with part # RVLG-RDBOX the jack legs would not free-spin and lower themselves so you could remove the box with the jacks holding the weight of the trailer or not. We do not carry the cross shafts for this jack though.
  view full answer...


• Recommended Trailer Hitch Receiver for 2008 KZ Spree 27 RLSE 5th Wheel Trailer
• For your 2008 KZ Spree 27 RLSE 5th wheel trailer, the Ultra-Fab 2" Trailer Hitch Receiver for Trailer Frames # UF35-946403 is a great weld on option that will give you a 3,500 lb towing capacity and a 350 lb tongue weight. For a bolt-on option, I recommend the Curt Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide # C13704 which is rated for trailers up to 3,500 lbs and 350 lb tongue weight. You can alternatively use the Curt # 13703 which uses a different style bracket...
  view full answer...


• Can HEPA Air Filters Be Added To An RV Air Conditioner
• We do carry replacement filter inserts for specific branded air distribution boxes like the Replacement 14" x 7-1/2" Air Filter for Dometic Duo-Therm RV Air Conditioner # RA48QV, but they aren't HEPA rated. I do know that you can get rolls of HEPA filter material that you could then cut to fit the vent opening of your air distribution box, but we don't currently carry this.
  view full answer...


• Instructions for Replacing Ventline Range Hood Fan Motor
• In a Ventline RV range hood such as # S0721-20BD-F-1 you will want to remove the grease filter to access the damaged motor to install a replacement like # BVD0278-00 which uses AC power or # BVD0218-00-R which uses DC power. Of course, make sure power is disconnected. We do not have a video showing the process but I was able to obtain from Ventline the written instructions for motor replacement for DC and AC motors. These have been forwarded to you in a separate email.
  view full answer...